From: Dinh Nguyen <dingu...@opensource.altera.com>
Add config for the Arria10 SoC Development Kit.
Signed-off-by: Dinh Nguyen <dingu...@opensource.altera.com>
---
v3: further clean up, remove extra defines, keep bare mininum options
v2: clean up socfpga_arria10_socdk.h to use socfpga_common.h
---
include/configs/socfpga_arria10_socdk.h | 94 +++++++++++++++++++++++++++++++++
1 file changed, 94 insertions(+)
create mode 100644 include/configs/socfpga_arria10_socdk.h
diff --git a/include/configs/socfpga_arria10_socdk.h
b/include/configs/socfpga_arria10_socdk.h
new file mode 100644
index 0000000..577f60f
--- /dev/null
+++ b/include/configs/socfpga_arria10_socdk.h
@@ -0,0 +1,94 @@
+/*
+ * Copyright (C) 2015 Altera Corporation <www.altera.com>
+ *
+ * SPDX-License-Identifier: GPL-2.0
+ */
+
+#ifndef __CONFIG_SOCFGPA_ARRIA10_H__
+#define __CONFIG_SOCFGPA_ARRIA10_H__
+
+#include <asm/arch/base_addr_a10.h>
+/* U-Boot Commands */
+#define CONFIG_SYS_NO_FLASH
+#define CONFIG_DOS_PARTITION
+#define CONFIG_FAT_WRITE
+#define CONFIG_HW_WATCHDOG
+
+#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_BOOTZ
+#define CONFIG_CMD_CACHE
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_EXT4
+#define CONFIG_CMD_EXT4_WRITE
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_FS_GENERIC
+#define CONFIG_CMD_GREPENV
+#define CONFIG_CMD_MMC
+#define CONFIG_CMD_PING
+
+/*
+ * Memory configurations
+ */
+#define PHYS_SDRAM_1_SIZE 0x2000000
+
+/* Booting Linux */
+#define CONFIG_BOOTDELAY 3
+#define CONFIG_BOOTFILE "zImage"
+#define CONFIG_BOOTARGS "console=ttyS0,"
__stringify(CONFIG_BAUDRATE)
+#define CONFIG_BOOTCOMMAND "run mmcload; run mmcboot"
+#define CONFIG_LOADADDR 0x01000000
+#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
+
+/*
+ * Display CPU and Board Info
+ */
+#define CONFIG_DISPLAY_CPUINFO
+#define CONFIG_DISPLAY_BOARDINFO
+#define CONFIG_DISPLAY_BOARDINFO_LATE
+
+/* Ethernet on SoC (EMAC) */
+#if defined(CONFIG_CMD_NET)
+
+/* PHY */
+#define CONFIG_PHY_MICREL
+#define CONFIG_PHY_MICREL_KSZ9031
+
+#endif
+
+#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_SYS_MMC_ENV_DEV 0/* device 0 */
+#define CONFIG_ENV_OFFSET 512/* just after the MBR */
+
+/*
+ * arguments passed to the bootz command. The value of
+ * CONFIG_BOOTARGS goes into the environment value "bootargs".
+ * Do note the value will overide also the chosen node in FDT blob.
+ */
+#define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE)
+
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ "verify=n\0" \
+ "loadaddr= " __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \
+ "ramboot=setenv bootargs " CONFIG_BOOTARGS ";" \
+ "bootm ${loadaddr} - ${fdt_addr}\0" \
+ "bootimage=zImage\0" \
+ "fdt_addr=100\0" \
+ "fdtimage=socfpga.dtb\0" \
+ "fsloadcmd=ext2load\0" \
+ "bootm ${loadaddr} - ${fdt_addr}\0" \
+ "mmcroot=/dev/mmcblk0p2\0" \
+ "mmcboot=setenv bootargs " CONFIG_BOOTARGS \
+ " root=${mmcroot} rw rootwait;" \
+ "bootz ${loadaddr} - ${fdt_addr}\0" \
+ "mmcload=mmc rescan;" \
+ "load mmc 0:1 ${loadaddr} ${bootimage};" \
+ "load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \
+ "qspiroot=/dev/mtdblock0\0" \
+ "qspirootfstype=jffs2\0" \
+ "qspiboot=setenv bootargs " CONFIG_BOOTARGS \
+ " root=${qspiroot} rw rootfstype=${qspirootfstype};"\
+ "bootm ${loadaddr} - ${fdt_addr}\0"
+
+/* The rest of the configuration is shared */
+#include <configs/socfpga_common.h>
+#endif /* __CONFIG_H */
--
2.6.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
