Change the axp223 dcdc2 / VDD-SYS default from 1.2V to 1.1V, 1.1V is the
value recommended by Allwinner and is what most fex files specify.
This has been tested on a number of A23/A33 tablets including on an
A23 Ippo-q8h-v1.2 PCB tablet which has a fex file which specifies 1.2V
(which is where our original 1.2V default comes from).
Signed-off-by: Hans de Goede <hdego...@redhat.com>
---
configs/gt90h_v4_defconfig | 1 -
drivers/power/Kconfig | 5 +++--
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/configs/gt90h_v4_defconfig b/configs/gt90h_v4_defconfig
index e6be718..e7347d8 100644
--- a/configs/gt90h_v4_defconfig
+++ b/configs/gt90h_v4_defconfig
@@ -20,7 +20,6 @@ CONFIG_SYS_EXTRA_OPTIONS="CONS_INDEX=5"
# CONFIG_CMD_IMLS is not set
# CONFIG_CMD_FLASH is not set
# CONFIG_CMD_FPGA is not set
-CONFIG_AXP_DCDC2_VOLT=1100
CONFIG_AXP_DLDO1_VOLT=3300
CONFIG_AXP_ALDO1_VOLT=3000
CONFIG_USB_MUSB_HOST=y
diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig
index 3a7b3f9..cedc36a 100644
--- a/drivers/power/Kconfig
+++ b/drivers/power/Kconfig
@@ -42,13 +42,14 @@ config AXP_DCDC2_VOLT
int "axp pmic dcdc2 voltage"
depends on AXP152_POWER || AXP209_POWER || AXP221_POWER
default 1400 if AXP152_POWER || AXP209_POWER
- default 1200 if MACH_SUN6I || MACH_SUN8I
+ default 1200 if MACH_SUN6I
+ default 1100 if MACH_SUN8I
---help---
Set the voltage (mV) to program the axp pmic dcdc2 at, set to 0 to
disable dcdc2.
On A10(s) / A13 / A20 boards dcdc2 is VDD-CPU and should be 1.4V.
On A31 boards dcdc2 is used for VDD-GPU and should be 1.2V.
- On A23/A33 boards dcdc2 is used for VDD-SYS and should be 1.2V.
+ On A23/A33 boards dcdc2 is used for VDD-SYS and should be 1.1V.
config AXP_DCDC3_VOLT
int "axp pmic dcdc3 voltage"
--
2.5.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
