Hi,
On 09-10-15 08:49, Ian Campbell wrote:
On Sat, 2015-10-03 at 16:26 +0200, Hans de Goede wrote:
Note that sun5i boards can have either an AXP209 or an AXP152 pmic,
Is it actually xor? I think so given that you later on unify the names
such that they cannot be compiled in at the same time.
If so then...
+config AXP152_POWER
+ boolean "axp152 pmic support"
+ depends on MACH_SUN5I
+ ---help---
+ Say y here to enable support for the axp152 pmic found on
most A10s
+ boards.
+
+config AXP209_POWER
+ boolean "axp209 pmic support"
+ depends on MACH_SUN4I || MACH_SUN5I || MACH_SUN7I
+ default y if MACH_SUN4I || MACH_SUN7I
+ ---help---
+ Say y here to enable support for the axp209 pmic found on
most
+ A10, A13 and A20 boards.
+
config AXP221_POWER
... these three ought to be inside a choice?
I was thinking the same, but on A80 boards there are 2
different axp chips, so if we make this a choice now we
just end up needing to revert this when we get full A80 support.
Regards,
Hans
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
