On 20:58 Thu 16 Jul , Prafulla Wadaskar wrote: > By default Auto Negotiation is enabled for interface speed > but on some platforms like RD6281A it does not work. > If you want to forced program it to desired speed, > this patch helps- > > Through this patch Auto negotiation can be disabled and > desired interface speed can be configured > > This patch is tested on RD6281A Kirkwood board > > Signed-off-by: Prafulla Wadaskar <prafu...@marvell.com> > --- > drivers/net/kirkwood_egiga.c | 24 ++++++++++++++++++++++++ > 1 files changed, 24 insertions(+), 0 deletions(-) > > diff --git a/drivers/net/kirkwood_egiga.c b/drivers/net/kirkwood_egiga.c > index 3c5db19..1dfd567 100644 > --- a/drivers/net/kirkwood_egiga.c > +++ b/drivers/net/kirkwood_egiga.c > @@ -415,7 +415,31 @@ static int kwgbe_init(struct eth_device *dev) > /* Assign port configuration and command. */ > KWGBEREG_WR(regs->pxc, PRT_CFG_VAL); > KWGBEREG_WR(regs->pxcx, PORT_CFG_EXTEND_VALUE); > + /* > + * Forced 10/100/1000BASE-T interface speed configuration > + * By default Auto Negotiation of interface speed is enabled > + * This can be forced disabled and desired speed can be configured > + */ > +#ifdef CONFIG_DIS_AUTO_NEG_SPEED_GMII > +#if (!defined (CONFIG_PHY_SPEED) || (CONFIG_PHY_SPEED == _1000BASET)) Could you find a better config taht _1000BASET & co
Best Regards, J. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
