Hi Simon, On Fri, Jul 31, 2015 at 11:31 PM, Simon Glass <s...@chromium.org> wrote: > This series allows U-Boot to be build as an EFI payload so that U-Boot > can be started on almost any x86 platform that supports EFI. This is > implemented as a stub which EFI can load plus a payload that is copied > to RAM. The payload contains a normal U-Boot binary image and device tree. > > This allows U-Boot to run on platforms that have EFI support but are not > supported natively by U-Boot. It also allows testing and fiddling with the > board using U-Boots memory display and other commands. > > In addition, U-Boot can be built as an EFI application. This should work > regardless of the board type since it only relies on EFI services. However > only 32-bit EFI is supported in this case. Again it can be used to snoop > around the platform. > > A README provides further details of how this series operates. >
I've finished the review for the v2 series. Testing shows that EFI application and EFI 64-bit stub works, but EFI 32-bit stub does not. There are two issues for 32-bit EFI stub. 1). the build issue in jump_to_uboot() in lib/efi/efi_stub.c 2). After fixing the build issue, the 32-bit EFI stub still does not boot. It reports error below. U-Boot 2015.07-00476-g8771bcb-dirty (Aug 04 2015 - 08:07:09 +0000) CPU: x86, vendor Intel, device 663h DRAM: Cannot find EFI memory map tables, ret=-93 initcall sequence 0115e954 failed at call 011126fd (err=-19) ### ERROR ### Please RESET the board ### Regards, Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot