If the SPL is to be used for Falcon mode then we need to make sure it
configures basic GPIO (iomux, padconf, and default output levels).
Signed-off-by: Tim Harvey <thar...@gateworks.com>
---
board/gateworks/gw_ventana/gw_ventana_spl.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/board/gateworks/gw_ventana/gw_ventana_spl.c
b/board/gateworks/gw_ventana/gw_ventana_spl.c
index 82078a0..cde04cf 100644
--- a/board/gateworks/gw_ventana/gw_ventana_spl.c
+++ b/board/gateworks/gw_ventana/gw_ventana_spl.c
@@ -510,6 +510,9 @@ void board_init_f(ulong dummy)
/* read/validate EEPROM info to determine board model and SDRAM cfg */
board_model = read_eeprom(CONFIG_I2C_GSC, &ventana_info);
+ /* configure model-specific gpio */
+ setup_iomux_gpio(board_model, &ventana_info);
+
/* provide some some default: 32bit 128MB */
if (GW_UNKNOWN == board_model) {
ventana_info.sdram_width = 2;
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
