On Tuesday, April 07, 2015 at 12:38:58 AM, Simon Glass wrote: > Hi Marek,
Hi Simon, > On 6 April 2015 at 07:13, Marek Vasut <ma...@denx.de> wrote: > > On Monday, April 06, 2015 at 01:38:13 AM, Simon Glass wrote: > >> Hi Marek, > > > > Hi Simon, > > > >> On 26 March 2015 at 13:40, Marek Vasut <ma...@denx.de> wrote: > >> > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote: > >> >> This series adds driver model support to USB. The intent is to permit > >> >> the various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any > >> >> number of USB ports of different types. > >> >> > >> >> With the RFC series, only USB controllers had a real driver model > >> >> device. USB devices (including the hub in the controller) were not > >> >> modelled as driver model devices. > >> >> > >> >> While this was expedient, and produced much fewer patches, it is not > >> >> a long-term solution. Also, since then, driver model Ethernet > >> >> support (which USB can use) has been merged to u-boot-dm/next. It > >> >> seems better to bite the bullet and do a full conversion. > >> > > >> > Whew. > >> > > >> > Reviewed-by: Marek Vasut <ma...@denx.de> > >> > >> Thanks very much for working through these! > >> > >> Unless there are other comments I plan to apply this to u-boot-dm/next > >> in the next few days. I expect it will need some tweaking as boards > >> are moved over too. > > > > Please apply, I'm really looking forward to this. > > > > Thank you very much for putting all the effort into this ! > > OK, I'll apply to u-boot-dm/next, do a bit more testing, and apply. It > will be great to get this moved over. Thank you! Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot