On Monday, April 06, 2015 at 01:38:13 AM, Simon Glass wrote: > Hi Marek,
Hi Simon, > On 26 March 2015 at 13:40, Marek Vasut <ma...@denx.de> wrote: > > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote: > >> This series adds driver model support to USB. The intent is to permit > >> the various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any > >> number of USB ports of different types. > >> > >> With the RFC series, only USB controllers had a real driver model > >> device. USB devices (including the hub in the controller) were not > >> modelled as driver model devices. > >> > >> While this was expedient, and produced much fewer patches, it is not a > >> long-term solution. Also, since then, driver model Ethernet support > >> (which USB can use) has been merged to u-boot-dm/next. It seems better > >> to bite the bullet and do a full conversion. > > > > Whew. > > > > Reviewed-by: Marek Vasut <ma...@denx.de> > > Thanks very much for working through these! > > Unless there are other comments I plan to apply this to u-boot-dm/next > in the next few days. I expect it will need some tweaking as boards > are moved over too. Please apply, I'm really looking forward to this. Thank you very much for putting all the effort into this ! Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
