Hi Marek, On 6 April 2015 at 07:13, Marek Vasut <ma...@denx.de> wrote: > On Monday, April 06, 2015 at 01:38:13 AM, Simon Glass wrote: >> Hi Marek, > > Hi Simon, > >> On 26 March 2015 at 13:40, Marek Vasut <ma...@denx.de> wrote: >> > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote: >> >> This series adds driver model support to USB. The intent is to permit >> >> the various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any >> >> number of USB ports of different types. >> >> >> >> With the RFC series, only USB controllers had a real driver model >> >> device. USB devices (including the hub in the controller) were not >> >> modelled as driver model devices. >> >> >> >> While this was expedient, and produced much fewer patches, it is not a >> >> long-term solution. Also, since then, driver model Ethernet support >> >> (which USB can use) has been merged to u-boot-dm/next. It seems better >> >> to bite the bullet and do a full conversion. >> > >> > Whew. >> > >> > Reviewed-by: Marek Vasut <ma...@denx.de> >> >> Thanks very much for working through these! >> >> Unless there are other comments I plan to apply this to u-boot-dm/next >> in the next few days. I expect it will need some tweaking as boards >> are moved over too. > > Please apply, I'm really looking forward to this. > > Thank you very much for putting all the effort into this !
OK, I'll apply to u-boot-dm/next, do a bit more testing, and apply. It will be great to get this moved over. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot