Hi,
On 29-12-14 17:23, Simon Glass wrote:
Hi Hans,
On 24 December 2014 at 09:47, Hans de Goede <hdego...@redhat.com> wrote:
Hi,
On 23-12-14 05:36, Simon Glass wrote:
Hi Hans,
On 22 December 2014 at 09:45, Hans de Goede <hdego...@redhat.com> wrote:
Hi,
On 21-12-14 19:52, Simon Glass wrote:
Hi,
I ran up a banana PI and noticed that HDMI works in U-Boot. Great!
Scrolling seems very slow though - is the L2 cache disabled perhaps?
I don't think so, but it could be, I think the scrolling code is just
very inefficient. Feel free to poke things a bit around this, ARM
cache management is not my forte.
I think it need ssomething like the code in exynos/soc.c - see
v7_outer_cache_enable().
Even with the 7 inch it's very slow.
I've run some tests, and it is not slower then on say the A10 (cortex A8),
also I've been unable to find any docs or allwinner code pointing to
allwinner specific l2 cache init. As such ATM I do not believe that we've
the l2 cache disabled.
Yes the code is not super-efficient (and could use the arch-specific
memcpy()) but I'm mostly interested in whether the platform is running
at full speed.
I'm comparing it to say an Exynos 5250 which is 1.7GHz Cortex-A15.
Without the L2 cache it scrolls quite slowly but with it it is fast.
Well this is a 1 GHz Cortex A7, and one with likely a much less
efficient DRAM controller / less DRAM bandwidth.
There is probably some cache setup required.
That could be, but if that is the case then I don't know where to start
looking for it. I certainly cannot find any such thing in allwinner;s
boot0 / boot1 bootloader.
Regards,
Hans
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
