Hi Akshay, On 13 October 2014 23:05, Akshay Saraswat <aksha...@samsung.com> wrote: > Hi Simon, > >> >>Hi Akshay, >> >>On 10 October 2014 05:50, Akshay Saraswat wrote: >>> >>> Hi Simon, >>> >>> > >>> >Hi Akshay, >>> > >>> >On 8 October 2014 02:10, Akshay Saraswat wrote: >>> >> Now we are adding a new Peach-Pi board which is a variant of Peach-Pit >>> >> and is based on Exynos5800. Exynos5800 itself is a variant of Exynos5420, >>> >> hence, most of the hardware config and settings are reused for this >>> >> board. >>> >> >>> >> Akshay Saraswat (5): >>> >> Exynos5800: Introduce new proid for Exynos5800 >>> >> Exynos5800: Add DTS for new board Peach-Pi >>> >> Config: Exynos5800: Enable build for Peach-Pi >>> >> Config: Exynos5420: Refactor SDRAM Bank and Size >>> >> Exynos5: ddr3: Choose between single or double channel config >>> >> >>> >> Alim Akhtar (1): >>> >> DMC: Exynos5: Enable update mode for DREX controller >>> > >>> >I was not able to apply this to samsung/master. I fiddled a bit and >>> >>> Few patches got merged after I posted this patch-set. I will Rebase it. >>> >>> >got it to build (see u-boot-x86.git branch pi-working) but it would >>> >not boot over USB A-A. It hung in SPL. I may have used an incorrect >>> >>> I don't have the SMDK for Exynos5800 and my cros_write_firmware always >>> fails to boot through USB. >>> I tested these patches with SD boot only. >>> >>> I could not find any difference between Pit and Pi. If Pit boots via USB >>> then Pi should also boot. >>> Plus, for both USB boot and SD boot, path is same till the point where it >>> starts loading U-Boot. >>> Please help me and let me know the steps for cros_write_firmware. I'll >>> debug and post new patches. >>> >>> BL1 that I used has the following md5 sum - >>> 23b60e72992d839195d48335865dbabb >> >>Ah, mine is c33215481b579405fafb579e323b4a74 - I wonder if that is the >>problem? Where is this file available? >> > > Thanks for verifying. This could be any intermediate bl1. When we migrated > from Pit to Pi we faced this issue. > So, we tested couple of binaries and one of them was able to do the USB > recovery other was not. > > I have this u-boot.bl1.bin in my /build/peach_pi/firmware and it does flash > firmware-pit-4482.B via USB. > Shall I send it to you ? or Will exynos-pre-boot download it ?
Yes please send it. I don't seem to be getting the same version, but perhaps it is because it is only on that branch? Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
