Hi Akshay,
On 10 October 2014 05:50, Akshay Saraswat <aksha...@samsung.com> wrote: > > Hi Simon, > > > > >Hi Akshay, > > > >On 8 October 2014 02:10, Akshay Saraswat wrote: > >> Now we are adding a new Peach-Pi board which is a variant of Peach-Pit > >> and is based on Exynos5800. Exynos5800 itself is a variant of Exynos5420, > >> hence, most of the hardware config and settings are reused for this board. > >> > >> Akshay Saraswat (5): > >> Exynos5800: Introduce new proid for Exynos5800 > >> Exynos5800: Add DTS for new board Peach-Pi > >> Config: Exynos5800: Enable build for Peach-Pi > >> Config: Exynos5420: Refactor SDRAM Bank and Size > >> Exynos5: ddr3: Choose between single or double channel config > >> > >> Alim Akhtar (1): > >> DMC: Exynos5: Enable update mode for DREX controller > > > >I was not able to apply this to samsung/master. I fiddled a bit and > > Few patches got merged after I posted this patch-set. I will Rebase it. > > >got it to build (see u-boot-x86.git branch pi-working) but it would > >not boot over USB A-A. It hung in SPL. I may have used an incorrect > > I don't have the SMDK for Exynos5800 and my cros_write_firmware always fails > to boot through USB. > I tested these patches with SD boot only. > > I could not find any difference between Pit and Pi. If Pit boots via USB then > Pi should also boot. > Plus, for both USB boot and SD boot, path is same till the point where it > starts loading U-Boot. > Please help me and let me know the steps for cros_write_firmware. I'll debug > and post new patches. > > BL1 that I used has the following md5 sum - > 23b60e72992d839195d48335865dbabb Ah, mine is c33215481b579405fafb579e323b4a74 - I wonder if that is the problem? Where is this file available? Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
