Hi Akshay, On 10 October 2014 05:50, Akshay Saraswat <aksha...@samsung.com> wrote: > Hi Simon, > >> >>Hi Akshay, >> >>On 8 October 2014 02:10, Akshay Saraswat wrote: >>> Now we are adding a new Peach-Pi board which is a variant of Peach-Pit >>> and is based on Exynos5800. Exynos5800 itself is a variant of Exynos5420, >>> hence, most of the hardware config and settings are reused for this board. >>> >>> Akshay Saraswat (5): >>> Exynos5800: Introduce new proid for Exynos5800 >>> Exynos5800: Add DTS for new board Peach-Pi >>> Config: Exynos5800: Enable build for Peach-Pi >>> Config: Exynos5420: Refactor SDRAM Bank and Size >>> Exynos5: ddr3: Choose between single or double channel config >>> >>> Alim Akhtar (1): >>> DMC: Exynos5: Enable update mode for DREX controller >> >>I was not able to apply this to samsung/master. I fiddled a bit and > > Few patches got merged after I posted this patch-set. I will Rebase it. > >>got it to build (see u-boot-x86.git branch pi-working) but it would >>not boot over USB A-A. It hung in SPL. I may have used an incorrect > > I don't have the SMDK for Exynos5800 and my cros_write_firmware always fails > to boot through USB. > I tested these patches with SD boot only. >
OK, it doesn't work on SD for me either. I think the best thing is to wait until you rebase and retest the patches then I'll try again. > I could not find any difference between Pit and Pi. If Pit boots via USB then > Pi should also boot. > Plus, for both USB boot and SD boot, path is same till the point where it > starts loading U-Boot. > Please help me and let me know the steps for cros_write_firmware. I'll debug > and post new patches. I am using crosfw which automates most of that (crosfw -b peach_pi) but I have had to change it to support pi (to use exynos5800 instead of exynos5420). I'll be away for a week but will take a look when I get back. > > BL1 that I used has the following md5 sum - > 23b60e72992d839195d48335865dbabb > >>option though. I'm pretty sure it is getting to BL2 since it says that PSHOLD is enabled. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
