> > On 09/03/2014 07:54 AM, Naitik Amin wrote: > > Hi Hannes, > > > > So I did as you had indicated and made some progress, so now, my #defines > > look as below. > > #define CONFIG_SYS_MMC_ENV_DEV 0 /* device 0 */ > > #define CONFIG_ENV_OFFSET 0x21900000 > > > > I calculated the env offset from the block number it was on based on the > > first block number of the partition. > > > > Doing this on uboot startup, I dont get the warning saying, using default > > environment. Neither it complained abt crc error. So it liked it seems. > > But what it did is it trashed the partition which had my dtb and zImage. > > Its a completely different partition. So after that, the bootup gets > > halted. Any ideas ? What may have trashed the partition ? > > Look at: http://www.mail-archive.com/u-boot@lists.denx.de/msg146396.html > > and see if that's relevant, specifically the second patch which restores
> the mmc device offset calculations to the values that correspond to the > partition number that's represented in the device structure. > > Peter Hi Peter, i don't think that your patch has influence on this issue, due to no partition switching is done anymore. Further i would like to check your patch series, i am not sure if there is everything ok. I will do so tommorow - i am right in thinking that you are using MMC not eMMC ? best regards, Hannes _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
