Thank you Sir for your response. As per your instruction I set "bootdelay" variable. log is given below, But the problem is not solve. I run command "run bootcmd" for booting the kernel.
------------------------------------------ LOG ------------------------------------------------------------- ramboot=setenv rootdev /dev/ram;run setbootargs;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr $ramdiskaddr $fdtaddr nfsboot=setenv rootdev /dev/nfs;run setbootargs;run setipargs;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr - $fdtaddr baudrate=115200 loads_echo=1 ethaddr=00:E0:0C:00:95:01 eth1addr=00:E0:0C:00:95:02 rootpath=/nfs/root/path hostname=mpc8313erdb bootfile=uImage loadaddr=200000 netdev=eth1 ethprime=TSEC1 uboot=u-boot.bin tftpflash=tftpboot $loadaddr $uboot; protect off 0xFE000000 +$filesize; erase 0xFE000000 +$filesize; cp.b $loadaddr 0xFE000000 $filesize; protect on 0xFE000000 +$filesize; cmp.b $e fdtaddr=400000 fdtfile=mpc8313erdb.dtb console=ttyS0 setbootargs=setenv bootargs root=$rootdev rw console=$console,$baudrate $othbootargs setipargs=setenv bootargs nfsroot=$serverip:$rootpath ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:$netdev:off root=$rootdev rw console=$console,$baudrate $othbootargs filesize=490000 fileaddr=100000 netmask=255.0.0.0 bootargs=root=/dev/mtdblock6 rootfstype=jffs2 rw console=ttyS0,115200 bootcmd=cp.b fe710000 40000 11000; go 40004; bootm fe100000 - fe700000 *bootdelay=3* stdin=serial stdout=serial stderr=serial ethact=TSEC1 -------------------------------------------------------------------------------------------------------------------------------------------------- Thanks In Advance. On Fri, May 22, 2009 at 4:22 PM, Wolfgang Denk <w...@denx.de> wrote: > Dear paras, > > In message <8136f0210905220236o93ab0a0gbf8ff5e15192e...@mail.gmail.com> > you wrote: > > > > I am working on MPC8313erdb board. I configure U-Boot 1.3.0 for my board, > > U-Boot 1.3.0 is very old. Why don't you use current code? > > > But the problem is on auto-boot. > > When I start the board it stop on command prompt of u-boot. > > That's normal given your setup. Try setting "bootdelay". > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de > "Do we define evil as the absence of goodness? It seems only logical > that shit happens--we discover this by the process of elimination." > -- Larry Wall >
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
