Hi Masahiro,
On Thu, 2014-02-27 at 23:35 +0900, Masahiro Yamada wrote:
> Hello Chin,
>
>
> > +
> > + nand->ecc.mode = NAND_ECC_HW;
> > + nand->ecc.size = CONFIG_NAND_DENALI_ECC_SIZE;
> > + nand->ecc.read_oob = denali_read_oob;
> > + nand->ecc.write_oob = denali_write_oob;
> > + nand->ecc.read_page = denali_read_page;
> > + nand->ecc.read_page_raw = denali_read_page_raw;
> > + nand->ecc.write_page = denali_write_page;
> > + nand->ecc.write_page_raw = denali_write_page_raw;
> > +#ifdef CONFIG_SYS_NAND_15BIT_HW_ECC_OOBFIRST
> > + /* 15bit ECC */
> > + nand->ecc.bytes = 26;
> > + nand->ecc.layout = &nand_15bit_oob;
> > +#else /* 8bit ECC */
> > + nand->ecc.bytes = 14;
> > + nand->ecc.layout = &nand_8bit_oob;
> > +#endif
> > + nand->ecc.calculate = denali_ecc_calculate;
> > + nand->ecc.correct = denali_ecc_correct;
> > + nand->ecc.hwctl = denali_ecc_hwctl;
>
> You set nand->ecc.mode = NAND_ECC_HW,
> but it looks like you don't set nand->ecc.strength.
>
> So, I think initialization will fail in nand_scan_tail() function.
>
> Here,
>
> if (mtd->writesize >= chip->ecc.size) {
> if (!chip->ecc.strength) {
> pr_warn("Driver must set ecc.strength when
> using hardware ECC\n");
> BUG();
> }
> break;
>
>
>
> Where do you set nand->ecc.strength?
I believe this is only applicable for NAND_ECC_HW_SYNDROME mode. We are
using the NAND_ECC_HW (without the syndrome). Wonder you hit error
during run?
Chin Liang
>
>
>
>
> Best Regards
> Masahiro Yamada
>
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
