Derek Ou wrote: > Wolfgang Denk wrote: > >> Dear Derek Ou, >> >> In message <49fa1279.5080...@siconix.com> you wrote: >> >> >>> When we have the Network support compiled, it takes a few second to do >>> the auto-negotiation >>> >>> >> That should be part of the network init sequence, which should only be >> run when you run a network command. >> >> > The board goes to auto-negotiation before boot delay count down. So > it's before I can run > any command. I will look into the network init routine then. > >>> even though MAC chip is not on board. Then it fails out and goes to >>> autoboot. Is it a board specific problem or system problem? >>> >>> >> Board (or architecture) problem. >> Which board / architecture is this? >> >> > It's an Atmel AT91SAM9263(ek) board. ARM architecture. > >> Best regards, >> Wolfgang Denk >> >> Do you have CONFIG_RESET_PHY_R defined? It forces a call to eth_init(), which most likely causes the delay you're seeing. Try commenting it out in your config file.
regards, Ben _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
