Dear Derek Ou, In message <49fa0922.2000...@siconix.com> you wrote: > > Other than recompiling, is it possible to disable Ethernet through > environment settings? At our
No. > work, we often need Ethernet only during development, manufacturing and > troubleshooting. So > we put the Ethernet chip on the test fixture instead of the final > board. However, compiling in > Ethernet slow down the booting process. So it will be great if Ethernet Why would compiled in Network support slow down the boot process? The network interface will only be initialized as soon as you use it. If you don't have one, then you probably will not try using it - then why would it delay your boot? > can be disabled and > enabled by flipping an environment setting. This cannot be done in the current code (and it should not be necessary). Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de "There are things that are so serious that you can only joke about them" - Heisenberg _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
