Hi Tom, Michael,
> Hello,
>
> The following changes since commit 3da0e5750b24a9491058df6126c7be577a276c09:
>
> arm: factorize relocate_code routine (2013-05-30 20:24:38 +0200)
>
> are available in the git repository at:
>
> git://git.denx.de/u-boot-ti.git master
>
> for you to fetch changes up to 80dd596d1b442ff53dbeb33eccdb8efd2283be79:
>
[snip]
> Michael Trimarchi (1):
> usb: omap: ulpi: fix ulpi transceiver access
[snip]
> drivers/usb/ulpi/omap-ulpi-viewport.c | 40 +-
[snip]
I just made a clean clone of u-boot-ti/master, manually applied the
changes to the ehci files, added my board files and made a build.
Everything seems to work fine, but I see an error message regarding
ULPI reset that was not present before, and obviously it is due to
Michael's changes:
SOM5_EVB # usb start
(Re)start USB...
USB0: ULPI: ulpi_reset: failed writing reset bit
USB EHCI 1.00
scanning bus 0 for devices... 6 USB Device(s) found
scanning usb for storage devices... 3 Storage Device(s) found
scanning usb for ethernet devices... 1 Ethernet Device(s) found
SOM5_EVB # usb tree
USB device tree:
1 Hub (480 Mb/s, 0mA)
| u-boot EHCI Host Controller
|
+-2 Mass Storage (480 Mb/s, 200mA)
| FSC MEMORYBIRD USB2 C157040817120315AA
|
+-3 Hub (480 Mb/s, 2mA)
| |
| +-4 Mass Storage (480 Mb/s, 96mA)
| | Generic Ultra Fast Media Reader 000000264001
| |
| +-5 Mass Storage (480 Mb/s, 100mA)
| USB Flash Drive 531C43B21928F11F
|
+-6 Vendor specific (480 Mb/s, 500mA)
SOM5_EVB #
Otherwise everything is OK, the device on the ULPI port is working
(it is #2 above). It is now late and I shall investigate in detail
tomorrow, this is just an early warning ;)
Best regards,
Lubo
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
