Thanks for the response, so the whoosh does not support holding a key to get into another image? I guess that won't work. So if I wanted to support the SPL on the nitrogent6x are there any instruction on what requirements it has to support it.
I'm guessing all the work I'd need to do is in board/boundary/nitrogen6x? Also how would I normally configure and build an spl for a working board. There is a lot of config options in the README for the spl. -----Original Message----- From: Alexandre Belloni [mailto:alexandre.bell...@piout.net] Sent: Tuesday, February 19, 2013 9:00 AM To: Wolfgang Denk Cc: Chaves, Kevin; u-boot@lists.denx.de; Dirk Behme Subject: Re: [U-Boot] imx6, spl and falcon boot On Tue, Feb 19, 2013 at 12:35:01PM +0100, Wolfgang Denk wrote : > Dear Alexandre Belloni, > > In message <20130219112532.gb24...@piout.net> you wrote: > > > > No, that is not supported and probably won't be. Some people will > > argue > > I think you are wrong. This is definitely a "not supported _yet_". > > > that you probably don't need a bootloader once you are able to boot > > a linux kernel as you can probably do everything you want from there. > > Yes, some people will think so, and some will actually do that. > Others (and I would expect these to be the majority) will realize the > benefits of being able to switch on demand (say, key press, jumper > setting, etc.) between different boot modes, boot images, etc. > > I am absolutely sure that SPL support for iMX6 will be added rather > sooner than later. > Yeah, don't misinterpret me, I was just saying that it will not be supported in whoosh. I also believe that SPL and falcon mode will come to i.mx6 and I'm also interested in getting that support ;) -- Alexandre Belloni _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot