Excellent thanks, the "falcon" boot or mode is booting directly into the kernel from the SPL and skipping uboot altogether.
-----Original Message----- From: Dirk Behme [mailto:dirk.be...@gmail.com] Sent: Saturday, February 16, 2013 2:32 AM To: Chaves, Kevin Cc: u-boot@lists.denx.de; Eric Nelson Subject: Re: [U-Boot] imx6, spl and falcon boot Am 15.02.2013 21:45, schrieb Chaves, Kevin: > > Hi, > > First off, sorry I'm not used to using mailing lists. I'm not sure if this is > the best way to dig for information. We've recently switched to uboot/linux > from wince and I'm trying to understand how configuring uboot works. I'm also > trying to find out how to use the SPL framework and possibly falcon mode with > a i.mx6 nitrogen6x board. I'd be delighted if any one could help! I haven't used spl and falcon mode, so I can't help with these. Regarding the general support for the i.mx6 nitrogen6x this isn't in U-Boot mainline, yet. Try to git pull the most recent U-Boot mainline from git://git.denx.de/u-boot.git [1] and apply the patch http://patchwork.ozlabs.org/patch/216991/ You should then be able to build one of the supported boards nitrogen6q nitrogen6dl nitrogen6s nitrogen6q2g nitrogen6dl2g nitrogen6s1g by make nitrogen6xxx_config make (replace the 'xxx' with the ending matching your board, e.g. 'q' if you have a Quad board). Best regards Dirk [1] http://git.denx.de/cgi-bin/gitweb.cgi?p=u-boot.git;a=summary _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot