Dear Jean-Christophe PLAGNIOL-VILLARD, In message <20090309111835.gj24...@game.jcrosoft.org> you wrote: > > > > > Why the #ifdef? Shutting down the console seems a good thing to me. > > > when using DCC we will not activate the at91 uart at all so we do not > > > have to > > > shut it down > > > > The #ifdef above does not seem to depend on DCC at all?
You did not answer this question. > > And what does it hurt if we always shut down the console? To me that > > looks clearer than an additional #ifdef. You did not answer this question. > > Finally, what if somebody wants to use DCC and an UART simultaneously? > > I guess that should be possible, too. > It's not possible if you do not use the DCC multi support because the DCC will > replace the uart. So what if we use "DCC multi support"? (whatever this is - or do you mean CONFIG_SERIAL_MULTI instead?) > We must shutdown the console only if we use it which is not the case when we > use > the DCC as principal serial You did not answer my question. Even if there is no need to shut it down if it was not used - what does it hurt if we do this always? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Mirrors should reflect a little before throwing back images. - Jean Cocteau _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
