Hi, everyone, I've run into another problem, and before I call Caldera, I thought I'd try the most helpful list I know of. I have an IBM NetFinity 1000 running Caldera OpenLinux 2.4. The system needs to be dual-homed, and the system seems to recognize both ethernet cards. One is on eth0, IRQ11, and is working properly. Network connectivity is just fine. The other is eth1, IRQ10, different I/O memory range from the first card. The box can ping itself at that address, but can't see any other box on that network, and nothing on that net can see this box. I went into the network settings with COAS and found that the default gateway wasn't set on eth1. I tried setting it, but the system would not save the new settings. Sometimes it gives me a python error saying it cannot communicate with the network, sometimes not. It reads: Error when executing command ip-config change eth1 the command produced the following output: SIOCADDRT: Network is unreachable eth1: initialization failed Everything in ifconfig looks normal. Both cards show up and the addresses are correct. I tried to take eth1 down that way, then reset the address. No difference. If I type in ifconfig eth1 up I do not get an error at all. There is no provision for adding a second interface in lisa, and adding it manually to the /etc/hosts file didn't change anything. Any suggestions? Regards, Caity _______________________________________________ techtalk mailing list [EMAIL PROTECTED] http://www.linux.org.uk/mailman/listinfo/techtalk
