url: http://escribe.com/health/thesilverlist/m62814.html
Re: CS>Yellow tinted CS!!
From: sol
Date: Sun, 28 Sep 2003 08:45:11
Hi Paula,
You are making very good cs!! Personally, I believe the ions are
most effective, and your reading of 16.9 uS indicates a high ionic
content indeed.
At 1 ppm per uS, this is about 17 ppm. This is much better than what
you can get from the 3 nines, and certainly good enough to destroy
the Shingles virus, which is one of the most difficult viruses to
kill.
The reason for the tint is some silver oxide and hydroxide particles
formed at the end of the brew, when the concentration of ions was
high enough for them to combine. The particles are too small to see,
but they bump into each other over time and stick due to the van Der
Waals force, and produce the yellow tint that you observe.
To give you an idea how strong it is, gecko lizards use the van Der
Waals force to walk upside-down on ceilings. Here are a couple of
short articles that describe it:
http://www.nature.com/nsu/000608/000608-11.html
http://www.berkeley.edu/news/media/releases/2000/06/07_gecko.html
The tint is harmless, but you could add a tiny bit of H2O2 to
convert the oxide and hydroxide back into usable ions. Try 1/4
teaspoon per litre, and let it sit overnight. It will stay clear,
and you probably won't even notice any taste from the H2O2.
You could also monitor the ppm near the end of the process, and stop
when it reaches 16 ppm or so. You might have to turn the current off
and wait for a couple of minutes to get an accurate reading.
The odd thing is you mention that all your cs generators do the same
thing. I would expect them to behave differently since they probably
have completely different electrode configurations and current
settings.
The only thing common to all the generators is the dw. Many people
have mentioned problems with different dw, and Robert an I both had
recent problems with our dw.
In my case, the WallMart dw worked fine for a couple of years, then
suddenly changed. It started leaving a hard black coat on the anode,
and the cs started showing a yellow tint where it was clear before.
It took a while to find another suitable dw, and about 7 batches to
get rid of the hard coat and start making clear cs again. I had to
reverse the electrode polarity each run, but eventually got both
electrodes clear again.
I actually prefer running the brew long enough to get a slight tint,
then add a smidge of H2O2 to keep it clear.
The reason is this gives the highest possible ion content, so I
don't have to use as much. I hold a mouthful for ten minutes, then
swallow it or spit it out.
The reason I think it works so well is our heart pumps enough blood
to circulate it all once per minute. So a high-ionic cs gives the
highest concentration in the blood before the liver starts
eliminating it from the blood stream. And the high concentration is
what kills the virus.
So relax. You are doing fine, and you are making very good cs!
Best Regards,
Mike Monett
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
