Your setup and CS is fine. Just brew for a longer time. Shoot for 15 to 20 ppm.
Many people try to brew with a current density under 1 milliamp per square inch of wetted silver electrode. The Faraday Calculator is explained at: <http://www.silvermedicine.org/faradaycalculator.html> There is a link to download the Xcell file right above the illustration of the spreadsheet. Dan On Wed, Apr 25, 2012 at 2:46 PM, Thomas Soares <[email protected]> wrote: > 2012/4/25 Dan Nave <[email protected]> >> >> Assuming that your current increases in a linear manner from .040 ma >> at start to 1.3 ma after 1 hour (avg of .67 ma over 1 hour), and 750ml >> water volume, the Faraday Calculator shows that you should have a >> maximum concentration of 3.6 ppm of silver. Not concentrated enough >> to dilute, barely adequate for use as it is. You should probably run >> this for another hour to get a higher concentration. > > > OK. Them if one uses amps as a measure of ppm, what is the range of current > to produce a good therapeutic solution ? > > TTS. -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>
