Hi,
does anyone have experience with this card under linux? is it supported
and are all of its features, especially analog in/out supported?
I'd like to know it before buying :) could be handy.
yours sincerely, Tjeerd Pinkert
---
This sf.net
Just some thoughts and XP I have had with my new Athlon 3200 (Barton 2.2GHz)
and ASUS A7NAX (nforce2) MoBo using RH9 with a 2.4.20-18-9custom.
Note: Video is ATI Radeon 9000 (250). Sound is i810_audio (nforce2 AC97
Audio Controller (MCP)).
I am encoding a test clip (2737 frames) recorded with a d
Op do 18-09-2003, om 15:48 schreef Ríkharður:
[...]
> Does anybody know where I can find those instructions ?
>
> I have looked around and found nothing..
>
If you go to the website of Pinnacle: http://www.pinnaclesys.com/,
choose ¨Support¨ and choose ¨Studio Version 8¨, the last entry in the
Ronald Bultje <[EMAIL PROTECTED]> writes:
>> At a certain point the numbers would just go nutzo, and usually
>> lavrec would bail with an audio sync error a few seconds later.
> Does the attached patch help?
As I mentioned, I've not played with recording for months and months, so
I do not currentl
Hi -
After the mail items about -Q yesterday I did a couple SVCD
encoding runs and the results are not what one would expect.
I'll leave out the yuvdenoise, etc stages - the basic mpeg2enc line used
(for the -Q 0 case) was:
mpeg2enc -M 2 -f 4 -q 6 -K
However, the 3ware cards, unless 3ware has introduced a cheap version
(I've not heard of it) are true real hardware raid. I've got one in
my pvr right now, it's an older 2 port model that isn't anywhere near
as fast as it's more modern cousins, but it's true full hardware
RAID, and only cost me ab
On Thu, Sep 18, 2003 at 08:40:43AM -0400, Matthew Caron wrote:
> >Right, I was thinking about a 3-ware IDE Raid. I'll have to compare
> >the two.
>
> Well, the one thing you have to be careful of is that a lot of the low
> end RAID controllers are essentially just hard disk controllers with
> l
G'day Ronald,
Not sure if you were suggesting it might help the errors I am getting with
the AWE64 but unfortunately it's still happening after the patch - not quite
as many errors if I use the -U option but still enough to cause the
"restart"
I'm going to swap out the soundcard from an AWE64 to
On Wed, Sep 17, 2003 at 06:30:15PM +0200, [EMAIL PROTECTED] wrote:
> It seems that the DC10 cannot properly handle smal fluctuations in the 5V
> line. This line can get polluted by other devices in your PC, especially
> by some graphic cards or the voltage regulators that feed your processor.
> You
Thanks. That's what I'd heard in the past (which is why my desktop
system is a Dual 2000+ system, but I wasn't sure whether this was
still considered to be true.
I'd say that it is still considered to be true.
Supports all current Athlon MP CPU's, and has a separate 64bit/66Mhz PCI
bus, which is
10 matches
Mail list logo
