Adam,
Take a look at the directive "Prefer Open Volumes". I had to set this
to No
to get concurrent jobs to run on 2 tape drives.
The only other significant difference that I see is that I have
AutoSelect
set to 'yes' in my config under the Device entry in the SD config file.
Alan Davis
Kern Sibbald a écrit :
> On Tuesday 20 February 2007 10:47, Adam Cécile wrote:
>
>> Hi,
>>
>> Any suggest I could start looking at ?
>>
>
> 1. Run the SD with debug level 100.
>
> 2. Look at doc for PreferMountedVolumes
>
Thanks a lot, it was my mistake ;-)
>
> 3. Although you provided y
On Tuesday 20 February 2007 10:47, Adam Cécile wrote:
> Hi,
>
> Any suggest I could start looking at ?
1. Run the SD with debug level 100.
2. Look at doc for PreferMountedVolumes
3. Although you provided your conf files (very useful), you did not say what
version of Bacula you are using (impor
Hi,
Any suggest I could start looking at ?
Regards, Adam Cécile.
Adam Cécile a écrit :
> Hello,
>
> I have set up a bacula installation with a Dell 132T autochanger (/dev/sg2).
> It has two LOT3 drives, /dev/nst0 and /dev/nst1.
> Both drives works fine with the mtx-changer script. Currently back
Hello,
I have set up a bacula installation with a Dell 132T autochanger (/dev/sg2).
It has two LOT3 drives, /dev/nst0 and /dev/nst1.
Both drives works fine with the mtx-changer script. Currently backup are
done but only used drive 0. I would like to run jobs on both drive 0 and
1, however when I
