On 10 Feb 2011, at 05:24, stef wrote:
> Le Wednesday 09 February 2011 18:01:08 Ben Green, vous avez ?crit : >> Hi >> I'm trying to configure various actions inside my Lide 60 such as >> analogue gain, tinkering with the calibration and the crop area that >> it scans with. >> >> The backend seems to have been abandoned on the support front - >> scanning is no problem, worked first time - its just this .conf file >> that i cannot drive? is there a list of commands I can feed into >> the .config file? like lamp on/off, red gain +3 ??? i'm afraid i dont >> speak Genesys? >> >> I have done this with some earlier LIDEs that worked with the plustec >> backend - these were quite straightforward - i could open the SANE >> prefs and turn calibration on/off, change gain and crop just by >> changing some zeros and ones.. however this genesys backend has only a >> list of scanners and their model/product addresses - I don't know what >> commands to put into the .conf file. >> >> I'm using SANE: mac10.6: >> >> TWAIN SANE Interface 2.9 binary http://www.ellert.se/twain-sane/ >> SANE Preference Pane 0.9 binary http://www.ellert.se/twain-sane/ SANE >> backends http://www.sane-project.org/ libusb 0.1.13 beta 2009-09-10 >> binary http://libusb.sourceforge.net/ >> >> >> Any Help is Much Appreciated.. >> >> >> Thnaks >> >> >> Ben > > Hello, > > all user settable settings are published by the backend through > options. > You can get the full list of active options for your model with 'scanimage -d > genesys --help'. There is no options or settings to modify in the conf file. > > Regards, > Stef > > -- > sane-devel mailing list: sane-devel at lists.alioth.debian.org > http://lists.alioth.debian.org/mailman/listinfo/sane-devel > Unsubscribe: Send mail with subject "unsubscribe your_password" > to sane-devel-request at lists.alioth.debian.org Hi Steph, Could you tell me how and where I use this command? (scanimage -d genesys --help) Is it in the SANE prefs file? if so, do i enter the command under my particular scanner model? I tried putting this command into terminal but got nothing back - Sorry I cant profess to know much about command line interface.. Thanks for you help.. Ben
