Le Wednesday 09 February 2011 18:01:08 Ben Green, vous avez ?crit :
> Hi
> I'm trying to configure various actions inside my Lide 60 such as
> analogue gain, tinkering with the calibration and the crop area that
> it scans with.
>
> The backend seems to have been abandoned on the support front -
> scanning is no problem, worked first time - its just this .conf file
> that i cannot drive? is there a list of commands I can feed into
> the .config file? like lamp on/off, red gain +3 ??? i'm afraid i dont
> speak Genesys?
>
> I have done this with some earlier LIDEs that worked with the plustec
> backend - these were quite straightforward - i could open the SANE
> prefs and turn calibration on/off, change gain and crop just by
> changing some zeros and ones.. however this genesys backend has only a
> list of scanners and their model/product addresses - I don't know what
> commands to put into the .conf file.
>
> I'm using SANE: mac10.6:
>
> TWAIN SANE Interface 2.9 binary http://www.ellert.se/twain-sane/
> SANE Preference Pane 0.9 binary http://www.ellert.se/twain-sane/ SANE
> backends http://www.sane-project.org/ libusb 0.1.13 beta 2009-09-10
> binary http://libusb.sourceforge.net/
>
>
> Any Help is Much Appreciated..
>
>
> Thnaks
>
>
> Ben
Hello,
all user settable settings are published by the backend through
options.
You can get the full list of active options for your model with 'scanimage -d
genesys --help'. There is no options or settings to modify in the conf file.
Regards,
Stef
