Thanks for the prompt reply, Peter. At your suggestion I tried another scsi cable but still get the same result. I don't know if the scanner has or needs a terminator, it worked OK without one when it was connected to a Macintosh. The scsi adapter is an Advansys 510 ISA. Think I could have a bad scsi card?
Thanks Bob On Monday 17 December 2001 12:37, you wrote: > Hi Bob, > > looks like your SCSI-communication is not ok. The printouts are correct > in some parts, but contain also some garbage. sane-find-scanner should > print > > found SCSI processor "HP C1130A 3540" at device /dev/scanner > > Can you check if you are using the right cable ? > > --Peter > > Bob Soukup wrote: > > I have an HP ScanJet 4p (C1130A) here that I can't get sane to recognize. > > I keep getting "no sane devices found". > > > > cat /proc/scsi/scsi gives: > > Attached devices: > > Host : scsi0 Channel: 00 Id: 02 Lun: 00 > > Vendor: HP Model: C1 0A Rev: 35 > > Type: Processor Ansi SCSI revision: ffffffff > > > > Doing "sane-find-scanner" yields: > > found SCSI processor "HPml us C1li0Aqt .3 /d 35/h" at device > > /dev/scanner found SCSI processor "HP/l al C1rc0Ari ir sr 35ST" at > > device /dev/sg0 found SCSI processor "HPml us C1li0Aqt .3 /d 35/h" at > > device /dev/sga > > > > Doing SANE_DEBUG_HP reports that dev/scanner does not seem to be an HP > > scanner. Also /dev/sg0 and /dev/sga report as not HP scanner. > > > > Anyone have suggestions as to how to get this puppy to work? > > > > Thanks > > > > Bob > > > > _______________________________________________ > > Sane-devel mailing list > > sane-de...@www.mostang.com > > http://www.mostang.com/mailman/listinfo/sane-devel
