Hi John Do you mean 30 amps dc or AC from the inverter?
Regardless I can only think the issue is programming. Is this a new issue after new equipment or ? Jay > On May 10, 2025, at 7:17 PM, John Blittersdorf via RE-wrenches > <[email protected]> wrote: > > > The system is Flexware 500 with 2 VFX3648 Master and slave L1, with FM100. > There are 2 Fortress eVault batteries and MATE3s and HUB. We had a problem > with charging going between 0 and approx 30 amps DC. The current would climb > up in about 10 seconds and then slowly go back to 0 in about the same amount > of time and then repeat. For some reason when we unplugged the FM100 from > the HUB, charging would resume at about 40 ADC continuous from the > generator.. This happens when the sun is out and when dark so the solar > input is having no effect on this strange behavior. Any ideas? > > John Blittersdorf > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/[email protected]/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > _______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/[email protected]/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
