Kristopher,
You might start with a smaller pilot hole and an easy-out or other
screw extractor. I have never seen this, so consider it just a
suggestion.
Allan
Allan Sindelar
[email protected]
NABCEP Certified PV
Installation Professional
NABCEP Certified Technical Sales Professional
New Mexico EE98J Journeyman Electrician
Founder (Retired), Positive
Energy,
Inc.
505 780-2738 cell
On 1/20/2016 2:53 PM, Kristopher Schmid
wrote:
Greetings,
Do any of you battery gurus have a suggestion for a
method of removing a bolt remnant that is corroded into a flag
terminal. Both sides snapped off flush with the flag. I was
thinking try to drill it out or maybe a small gear pulling
tool? I will never again use the non stainless hardware
supplied by the manufacturer...
Picture attached for reference.
Thanks!
_______________________________________________
List sponsored by Redwood Alliance
List Address: [email protected]
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://www.mail-archive.com/[email protected]/maillist.html
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
|
_______________________________________________
List sponsored by Redwood Alliance
List Address: [email protected]
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://www.mail-archive.com/[email protected]/maillist.html
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
