Ray,
I'm assuming this is a quick release axle. If so
the axle is normally 11mm longer than the hub
spacing. So if you set the one side so that
5.5mm of axle extends beyond the locknut your
other side should come out just about the
same. As others have already said, it doesn't
need to be exact, as long as the axle does not extend beyond the droupout.
Kerry Kunsman
San Diego, CA
At 09:24 AM 5/28/2010, Ray wrote:
Short version: I had the rear hub axle of the Atlantis apart and had
carefully laid out the parts on a cookie tin in the order that I had
removed each from the axle, including the ball bearings. I had left
one cone on the axle, just as the books and videoes all recommend.
Over skips my four-year-old granddaughter to see what's happening with
grandpa. She naturally grabs the edge of tin to lift her head over to
see, and … well, you can imagine the rest of the story.
It took a while, but I managed to locate every piece, including all 18
ball bearings. (A magnet duct-taped to stick worked really well for
this recovery mission. It also helped that each bearing was still
greased and not anxious to roll all over the garage floor.) I down-
loaded the schematic of the hub from the Shimano site, and in-fact had
recovered all the various bits and pieces. I threw everything into a
can of Orange, scrubbed, then rinsed and sun dried on the deck. Then,
all a-fluster (still angry at myself for being so careless knowing the
kids were here), and without thinking, I removed the one cone from the
axle to carefully clean all the threads. They sure do look shiny and
great now, but I soon realized that I can't readily center my axle/
wheel without a whole bunch of trial and error adjusting… on, off… on,
off… etc.
Tips, techniques, and short-cuts VERY MUCH appreciated…
--
You received this message because you are
subscribed to the Google Groups "RBW Owners Bunch" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/rbw-owners-bunch?hl=en.
Content-Type: multipart/alternative;
boundary="=======AVGMAIL-25825172======="
--=======AVGMAIL-25825172=======--
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.819 / Virus Database: 271.1.1/2901
- Release Date: 05/27/10 23:25:00
--
You received this message because you are subscribed to the Google Groups "RBW
Owners Bunch" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/rbw-owners-bunch?hl=en.
