I don't notice the issue. Have the same brakes on my Hillborne. 56cm size. Am running the brakes with the springs in the "tightest" position. The top of the three holes.
Almost sounds like you have too much braking force to cause the shudder. Have you tried playing around with straddle cable height? Eric Platt St. Paul, MN On Apr 16, 6:03�pm, MikeC <mecinib...@sbcglobal.net> wrote: > I have a Sam Hill with Tektro CR720's. They have a brass bushing that > pivots on the canti post. There is a lot of play in the pivot due to > the bushing being larger in diameter and shorter in length than the > post, which means it can wobble back and forth and side ways. It does > not pose a problem when braking at moderate to high speed, but when > slowing to a stop at low speed, like coasting with the brakes on into > the driveway at a few MPH, the fork shutters almost uncontrollably. > This is a 60 cm SH so the cable stops is way above the brakes due to > the long headtube, but the issues is mostly slop in the pivots more so > than the issue that Leonard Zinn referred to due to th ecable stop > being way above the brakes. > > Have any other SH owners run into this problem. I would imagine that > other Rivendell owners would also experience this assuming that the > same canti posts are likely used on all models. Any suggestions on how > to improve the situation, preferrably by reducing play at the pivots. > Otherwise, I really like the CR720 cantis with Kool Stop salmon pads. > > Mike C. > > -- > You received this message because you are subscribed to the Google Groups > "RBW Owners Bunch" group. > To post to this group, send email to rbw-owners-bu...@googlegroups.com. > To unsubscribe from this group, send email to > rbw-owners-bunch+unsubscr...@googlegroups.com. > For more options, visit this group > athttp://groups.google.com/group/rbw-owners-bunch?hl=en. -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To post to this group, send email to rbw-owners-bu...@googlegroups.com. To unsubscribe from this group, send email to rbw-owners-bunch+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en.
