This series fixes several problems I ran into while trying to simulate the AMD/Xilinx Versal CANFD controller in the xlnx-versal-virt machine using Xilinx's v6.6_LTS_2024.1 kernel. With all of these patches applied, everything works correctly alongside actual CAN devices.
- IRQs were accidentally not being delivered due to having a level other than 1. The IRQ count in /proc/interrupts in Linux was stuck at 0. - Incoming CAN FD frames were being treated as non-FD. - The CAN IDs were garbled in both RX and TX directions. - The byte ordering was wrong in the data in both directions. - Incoming CAN FD frames with DLC = 1-7 weren't handled correctly. I don't have any actual Versal hardware to compare behavior against, but with these changes, it plays nicely with SocketCAN on the host system. Doug Brown (5): hw/net/can/xlnx-versal-canfd: Fix interrupt level hw/net/can/xlnx-versal-canfd: Fix CAN FD flag check hw/net/can/xlnx-versal-canfd: Translate CAN ID registers hw/net/can/xlnx-versal-canfd: Fix byte ordering hw/net/can/xlnx-versal-canfd: Handle RX of short FD frames hw/net/can/xlnx-versal-canfd.c | 82 +++++++++++++++++++++++++++------- 1 file changed, 67 insertions(+), 15 deletions(-) -- 2.34.1
