Thanks for your help in installing Paraview on a raspberry pi. I
followed the steps in:
http://www.paraview.org/Wiki/ParaView:Build_And_Install
However, when I configure ccmake it says QT is needed. I could not
figure out if I can ignore that. The "generate" command did not come up.
On a side note, it took me a while to find ccmake. I thought it was
installed with cmake, but seems I had to install it separately using
"sudo apt-get install cmake-curses-gui" . Perhaps the instructions
should be updated to reflect this to avoid confusion.
Quoting Sebastien Jourdain <[email protected]>:
Wow,
I'm not an expert on raspberry pi but it should be possible.
BUT, (and it is a big but) you need some graphics capability for ParaView
or good CPUs if you don't have a GPU.
Or the rendering will be really slow.
The quicker test you can do, is to build ParaView (without Qt) and try to
run Visualizer with that ParaView in the command line to see what
performance you are getting. If that's reasonable, then all the network
setup should be "trivial".
ParaView: http://www.paraview.org/Wiki/ParaView:Build_And_Install
Visualizer: https://kitware.github.io/visualizer/
Good luck,
Seb
On Wed, Feb 8, 2017 at 8:15 AM, Faraz Hussain <[email protected]> wrote:
I want to be able to manipulate vtk file on my raspberry pi via a web
browser anywhere in the world. I believe I need to install paraviewweb and
do some reconfiguration of apache and the virtual hosts? Unfortunately, I
am not a guru of Linux. So before I attempt it all, is it even possible to
do this on a raspberry pi? I am using raspian .
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at http://www.kitware.com/opensou
rce/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Search the list archives at: http://markmail.org/search/?q=ParaView
Follow this link to subscribe/unsubscribe:
http://public.kitware.com/mailman/listinfo/paraview
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Search the list archives at: http://markmail.org/search/?q=ParaView
Follow this link to subscribe/unsubscribe:
http://public.kitware.com/mailman/listinfo/paraview
