Sorry , I'll confirm this and reply you later:-) 2015-02-19 16:39 GMT+08:00 Mikko Hissa <mikko.hi...@werzek.com>:
> > On 19 Feb 2015, at 10:32, 郭传鈜 <gch981...@gmail.com> wrote: > > I've just changed the fpa2 value to 0x25502f28 (Port 5 is force enabled > now) so swconfig shows the port as "Link down". > > > Yes, there's also POC0 register used to disable ports. It's default value > is set by bootloader. Swconfig should show an option disabled or similiar > under each port. What does it show? > > > RTL8211CL isn't a switch.It's just a gigabit PHY and other 4 ports of this > router is connected to the intergated switch:-) > > 2015-02-19 16:01 GMT+08:00 Mikko Hissa <mikko.hi...@werzek.com>: > >> >> On 19 Feb 2015, at 09:45, 郭传鈜 <gch981...@gmail.com> wrote: >> >> Portmap?This value is only for the default VLAN config of the switch >> right? But the problem I'm facing is that the link status of port 5 is >> always "link down" even if I plugged in the network cable:-( >> >> >> Actually no, the switch has like two logical switches and it doesn't >> forward packets between those two (LAN/WAN). >> Does swconfig show the port as disabled? >> >> >> 2015-02-19 15:24 GMT+08:00 Mikko Hissa <mikko.hi...@werzek.com>: >> >>> Hi! >>> >>> On 19 Feb 2015, at 04:14, 郭传鈜 <gch981...@gmail.com> wrote: >>> >>> Hello,everyone! >>> There is a kind of Huawei HG255D which has an RTL8211CL Gigabit PHY and >>> We are trying to add support for it. >>> But I can't find anything about the RGMII and mdio-bus in any dts file >>> of rt305x-based devices:-( >>> The only device I found which used the interface is WL-351 with an >>> RTL8366 switch but it doesn't use the MDIO interface to control it. I >>> tried to copy the fpa2 and fct2 value from WL-351.dts but ,of course, it >>> doesn't work. >>> Then I tried to do the following: >>> >>> https://github.com/981213/openwrt/commit/47fa84df4dcc9b8bfe49ed2211d463ed014e2df2 >>> >>> >>> Yes, there's that and then you need to configure registers for gdma2 in >>> the ethernet driver... Register a second netdev and map packets, to the >>> corresponding netdev/gdma (in/out) interface, by dma descriptors. >>> >>> OR >>> >>> In the dst file under the esw, change the value of portmap to 3f. >>> XD >>> >>> >>> but it doesn't work too. >>> Could someone please tell me what should I do in the dts file and how >>> can I reset the PHY? >>> >>> >>> Sorry for my bad English:-) >>> >>> _______________________________________________ >>> openwrt-devel mailing list >>> openwrt-devel@lists.openwrt.org >>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >>> >>> >>> >> >> > >
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
