The load command produces the same error for the external flash region.. I see no difference in the flash commands and the load command.
-----Ursprüngliche Nachricht----- Von: Øyvind Harboe [mailto:oyvind.har...@zylin.com] Gesendet: Mittwoch, 1. Dezember 2010 09:02 An: Star Keeper Cc: openocd-development@lists.berlios.de Betreff: Re: [Openocd-development] Programming external flash with OpenOCD fails On Wed, Dec 1, 2010 at 8:58 AM, Star Keeper <starkee...@gmx.at> wrote: > The image I want to flash is not my program code. It is a resource file with image data. > As i understand, the "load" command normally loads a program into RAM >and does not program a flash. Is that right, or should the load command >notice that the target address is in Flash and start the flash programming? That's right. "load" will look at the configuration and if the memory range is flash, then the flash is erased and programmed. -- Øyvind Harboe Can Zylin Consulting help on your project? US toll free 1-866-980-3434 / International +47 51 63 25 00 http://www.zylin.com/zy1000.html ARM7 ARM9 ARM11 XScale Cortex JTAG debugger and flash programmer _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
