The image I want to flash is not my program code. It is a resource file with image data. As i understand, the "load" command normally loads a program into RAM and does not program a flash. Is that right, or should the load command notice that the target address is in Flash and start the flash programming?
-------- Original-Nachricht -------- > Datum: Wed, 1 Dec 2010 08:43:28 +0100 > Von: "Øyvind Harboe" <oyvind.har...@zylin.com> > An: starkee...@gmx.at > CC: openocd-development@lists.berlios.de > Betreff: Re: [Openocd-development] Programming external flash with OpenOCD > fails > Normally you should be able to connect and flash by: > > target remote localhost:3333 > monitor reset init > load > stepi > > > > -- > Øyvind Harboe > > Can Zylin Consulting help on your project? > > US toll free 1-866-980-3434 / International +47 51 63 25 00 > > http://www.zylin.com/zy1000.html > ARM7 ARM9 ARM11 XScale Cortex > JTAG debugger and flash programmer -- GMX DSL Doppel-Flat ab 19,99 €/mtl.! Jetzt auch mit gratis Notebook-Flat! http://portal.gmx.net/de/go/dsl _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
