>> Can anyone verify that this interface is still functional in 0.4 ? Out >> of 0.4-rc1, 0.3.1 and an old rev.131 fetch only the old rev.131 fetch >> works to a certain extent. In all cases the openocd was built from >> source on cygwin with only amt_jtagaccell and parport_give_io enabled >> in configure. > >Since you have a test-case of sorts, could you do a git-bisect on it? >Just type the following: > >git bisect start >git bisect good v0.3.1 >git bisect bad v0.4.0-rc1 > >Then, repetitively: >./bootstrap >./configure --whatever-opts-you-use >make -j3 >src/openocd -f /path/to/your/config.conf >git bisect <good|bad> > >Once it says you're done, run "git describe" and report the output here.
Spooky, about 10 years ago when i started this job my manager was called Alex Austin, for a moment i had visions of cleaning EEPROM's with pink industrial alcohol again. I will have a look when i have some time, and if git works on cygwin. - Matthew ********************************************************************** Serck Controls Ltd, Rowley Drive, Coventry, CV3 4FH, UK A company registered in England Reg. No. 4353634 Tel: +44 (0) 24 7630 5050 Fax: +44 (0) 24 7630 2437 Web: www.serck-controls.com Admin: p...@serck-controls.co.uk A subsidiary of Serck Controls Pty. Ltd. ********************************************************************** This email and files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the above. Any views or opinions presented are those of the author and do not necessarily represent those of Serck Controls Ltd. This message has been scanned for malware by Mailcontrol. www.Mailcontrol.com _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
