Hallo jankomEarthlink wrote: > Sorry for the late reaction and thanks. I was traveling. No Problem.
> Bernhard Praschinger wrote: >> You can change the check in the configure script: > This really helped. Not changing the script, but studying and trying > to understand the entire thing. In fact, I found the problem! > SOLUTION: I did not have the SDL development rpm installed, so after > installing it software encoder was included. As I mentioned before, > this is now a completely restored FC -3 installation, and I have > failed to install all development packages. In the past this was not > a problem, because when I bastardized the system I installed > components by compiling source codes. Again, I have learned > something. Thank you for your patience and guidance. That's good. >> Did you try downloading the latest (or newer) mjpeg-tools tar.gz >> package unpacking it to a folder and try t compile it ? > Not yet, I hope my system will work as it is. It did work in the > past. All I'm trying to do is to create a "normal", not "bastardized" > system, and only install additional source codes if they are not part > of the original set-up, such as video editing. Ok. > NEW PROBLEM: Now that I compiled again glav works, it plays the > test.avi file I captured from my video recorder. However, there is no > sound. I had this problem before, and at the time the solution was > not to over-modulate the sound while recording, i.e. to keep capture > volume low. This time no matter what I do with recording levels glav > has no sound. I can play the video clip with xine, the sound is fine > (louder or softer depending on the setting at capture), but glav > produces no sound. Any suggestions? Could this be something like not > having some devel rpm installed? When I compiled mjpegtools > everything was OK (configure, make, make check, make install). Just > to summarize: streamer does record an avi file with video and audio > content that can play normally in xine, however glav only shows video > without sound. You can use the -U/--use-write Option and see if that helps. Did you check the mixer settings when you play back the file ? It could be that environment Variable LAV_AUDIO_DEV is set wrong. Can you run lavinfo filename.avi and post at least the audio related info, it should look like that: has_audio=1 audio_bps=4 audio_chans=2 audio_bits=16 audio_rate=44100 ---ENDE--- > P.S. One other thing: I did not get email from the mailing list, so I > copied and pasted the last message from the web site. I hope that it works this time they way it should. auf hoffentlich bald, Berni the Chaos of Woodquarter Email: shadowl...@utanet.at www: http://www.lysator.liu.se/~gz/bernhard ------------------------------------------------------------------------------ _______________________________________________ Mjpeg-users mailing list Mjpeg-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/mjpeg-users
