On Wed, 30 Jan 2008, Stuart Henderson wrote:
On 2008/01/30 15:26, Dennis Davis wrote:
"wireless driver reports an error and does not work" is short on
detail. It might just be that non-free firmware needs installing
(eg the firmware for the iwi driver) to get it to work.
people with Eee PC need to test -current snapshots, the wd/wdc
changes which are in them (not yet committed) will affect you
(hopefully to your advantage, there should be much lower cpu
use during disk activity).
So, installed current from Jan 28 on an usb stick and booted. Ethernet
works fine on the eee, but the wireless always reports
ath0: unable to reset hardware; hal status 4096
when I want to set something.
according to the manpage, this should not happen.
dmesg follows...
OpenBSD 4.2-current (GENERIC) #652: Mon Jan 28 14:04:36 MST 2008
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel(R) Celeron(R) M processor 900MHz ("GenuineIntel"
686-class) 631 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,CFLUSH,DS,ACPI,MMX,FXSR,SSE,SSE2,SS,TM,SBF
real mem = 527527936 (503MB)
avail mem = 502153216 (478MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 01/04/08, BIOS32 rev. 0 @
0xf0010, SMBIOS rev. 2.5 @ 0xf06c0 (37 entries)
bios0: vendor American Megatrends Inc. version "0703" date
01/04/2008
bios0: ASUSTeK Computer INC. 701
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 3.0 @ 0xf0000/0x10000
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf76b0/176 (9 entries)
pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82801FB LPC" rev
0x00)
pcibios0: PCI bus #5 is the last bus
bios0: ROM list: 0xc0000/0xf800!
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82915GM Host" rev 0x04
agp0 at pchb0: aperture at 0xd0000000, size 0x10000000
vga1 at pci0 dev 2 function 0 "Intel 82915GM Video" rev 0x04
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
"Intel 82915GM Video" rev 0x04 at pci0 dev 2 function 1 not
configured
azalia0 at pci0 dev 27 function 0 "Intel 82801FB HD Audio" rev 0x04:
irq 5
azalia0: codec[s]: Realtek/0x0662
audio0 at azalia0
ppb0 at pci0 dev 28 function 0 "Intel 82801FB PCIE" rev 0x04: irq 5
pci1 at ppb0 bus 4
ppb1 at pci0 dev 28 function 1 "Intel 82801FB PCIE" rev 0x04: irq 11
pci2 at ppb1 bus 3
lii0 at pci2 dev 0 function 0 "Attansic Technology L2" rev 0xa0: irq
11, address 00:1e:8c:b9:38:d8
ukphy0 at lii0 phy 1: Generic IEEE 802.3u media interface, rev. 2:
OUI 0x001374, model 0x0002
ppb2 at pci0 dev 28 function 2 "Intel 82801FB PCIE" rev 0x04: irq 10
pci3 at ppb2 bus 1
ath0 at pci3 dev 0 function 0 "Atheros AR5424" rev 0x01: irq 10
ath0: AR5424 14.2 phy 7.0 rf 0.0, WOR0W, address 00:15:af:75:d9:e0
uhci0 at pci0 dev 29 function 0 "Intel 82801FB USB" rev 0x04: irq 3
uhci1 at pci0 dev 29 function 1 "Intel 82801FB USB" rev 0x04: irq 7
uhci2 at pci0 dev 29 function 2 "Intel 82801FB USB" rev 0x04: irq 10
uhci3 at pci0 dev 29 function 3 "Intel 82801FB USB" rev 0x04: irq 5
ehci0 at pci0 dev 29 function 7 "Intel 82801FB USB" rev 0x04: irq 3
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "Intel EHCI root hub" rev 2.00/1.00 addr 1
ppb3 at pci0 dev 30 function 0 "Intel 82801BAM Hub-to-PCI" rev 0xd4
pci4 at ppb3 bus 5
ichpcib0 at pci0 dev 31 function 0 "Intel 82801FBM LPC" rev 0x04: PM
disabled
pciide0 at pci0 dev 31 function 2 "Intel 82801FBM SATA" rev 0x04:
DMA, channel 0 wired to compatibility, channel 1 wired to
compatibility
wd0 at pciide0 channel 1 drive 0: <SILICONMOTION SM223AC>
wd0: 1-sector PIO, LBA, 3815MB, 7815024 sectors
wd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 4
ichiic0 at pci0 dev 31 function 3 "Intel 82801FB SMBus" rev 0x04:
irq 7
iic0 at ichiic0
spdmem0 at iic0 addr 0x50: 512MB DDR2 SDRAM non-parity PC2-5300CL5
SO-DIMM
usb1 at uhci0: USB revision 1.0
uhub1 at usb1 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci1: USB revision 1.0
uhub2 at usb2 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci2: USB revision 1.0
uhub3 at usb3 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb4 at uhci3: USB revision 1.0
uhub4 at usb4 "Intel UHCI root hub" rev 1.00/1.00 addr 1
isa0 at ichpcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
biomask e7fd netmask effd ttymask ffff
mtrr: Pentium Pro MTRR support
umass0 at uhub0 port 3 configuration 1 interface 0 "USBest
Technology USB Mass Storage Device" rev 2.00/1.00 addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets
sd0 at scsibus0 targ 1 lun 0: <Ut163, USB2FlashStorage, 0.00> SCSI2
0/direct removable
sd0: 963MB, 122 cyl, 255 head, 63 sec, 512 bytes/sec, 1974271 sec
total
umass1 at uhub0 port 5 configuration 1 interface 0 "ENE UB6225" rev
2.00/1.00 addr 3
umass1: using SCSI over Bulk-Only
scsibus1 at umass1: 2 targets
sd1 at scsibus1 targ 1 lun 0: <USB2.0, CardReader SD0, 0100> SCSI0
0/direct removable
sd1: drive offline
softraid0 at root
root on sd0a swap on sd0b dump on sd0b
--
andre
