Hi Joe....
I spent a few hours tackling Netinstall and I can not get it to work. If
I connect ether8 to the network it pulls a DHCP but if I connect ether8
to my laptop through a cross-over cable nothing happens. I turned off
AVG protection as well as the default windows firewall. If I let the
router boot, I can ping ether8 from the laptop using the x-over cable
and ether8 set to 10Mbps. The laptop can be set to Auto OR 10M fixed.
Netinstall never sees the bootp request and the netinstall gui only
shows disk drives.
ANy ideas?
Thanks leon
On 3/19/2019 11:34 AM, Joe Novak wrote:
CCR support was added in 6.x if I'm not mistaken. The bootloader
version may have 3.09, though.
Assuming you've netinstalled the OS... I'm not sure there is much else
to do. You can try to swap in the ram from a known good router, same
with power supply. But that is more or less the extent of
troubleshooting I think you can do.
On Tue, Mar 19, 2019 at 10:21 AM Leon Zetekoff via Mikrotik-users
<[email protected] <mailto:[email protected]>> wrote:
Hi Folks....this device was given to us a number of years ago and
it had
3.09 on it I believe. We eventually upgraded it to 6.41.rc9 I
think it
was and started to act flooey. Put it on shelf since no time to deal
with it. Resurrected it again and i manually upgraded it to 6.42.12.
Whats going on is the ethernet ports only show 10Mbps, auto or
anything
other than 10M doesnt work. ALso only seems I can only talk to my
laptop. Mikrotik (and I) believe its a hardware issue and of
course out
of warranty.
Anyone else seen this before and any way to resolve it other than
tossing it in the trash bin?
Thanks leon
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Mikrotik-users mailing list
[email protected] <mailto:[email protected]>
http://lists.wispa.org/mailman/listinfo/mikrotik-users
_______________________________________________
Mikrotik-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/mikrotik-users
