Hi Aijun,
please look at rfc5316, ISIS already have a way to advertise inter-AS
link without forming an adjacency.
thanks,
Peter
On 05/11/2020 02:15, Aijun Wang wrote:
Hi, Acee:
Thanks for this comments.
The consideration for the position of flagging the passive interface have been
stated in the updated 05 version
https://tools.ietf.org/html/draft-wang-lsr-passive-interface-attribute-05#section-3,
as the followings:
ISIS [RFC5029] defines the Link-Attributes Sub-TLV to carry the link
attribute information, but this Sub-TLV can only be carried within
the TLV 22, which is used to described the attached neighbor. For
passive interface, there is no ISIS neighbor, then it is not
appropriate to use this Sub-TLV to indicate the passive attribute of
the interface.
OSPFv2[RFC2328] defines link type field within Router LSA, the type 3
for connections to a stub network can be used to identified the
passive interface. But in OSPFv3 [RFC5340], type 3 within the
Router-LSA has been reserved. The information that associated with
stub network has been put in the Intra-Area-Prefix-LSAs.
What about your opinions regarding to the above statements? Currently, we think
putting the flag within the prefix attribute that associated the passive
interface is appropriate.
If we can find other appropriate/acceptable place to hold this information, we
can also update the draft later accordingly.
Best Regards
Aijun Wang
China Telecom
-----Original Message-----
From: Acee Lindem (acee) [mailto:[email protected]]
Sent: Thursday, November 5, 2020 4:11 AM
To: Aijun Wang <[email protected]>
Cc: Aijun Wang <[email protected]>; Peter Psenak (ppsenak)
<[email protected]>; [email protected]
Subject: Re: [Lsr] FW: New Version Notification for
draft-wang-lsr-passive-interface-attribute-04.txt
Hi Aijun,
You still didn't answer the question as to why you didn't rework this draft for
passive interface to be an interface attribute rather than a prefix attribute?
Thanks,
Acee
On 10/1/20, 6:13 AM, "Acee Lindem (acee)" <[email protected]> wrote:
Hi Aijun,
You didn't answer my question and pruned my message. Other than your
attempt to expose the topology of areas outside the area, there is no other
reason to associate the passive interface attribute with a prefix. We seem to
be in a circular discussion....
Acee
On 9/30/20, 10:43 PM, "[email protected] on behalf of Aijun Wang"
<[email protected]> wrote:
Hi, Acee:
Except the corner cases of unnumbered interface, would you like to
illustrate other scenarios that the process does not apply?
As mentioned in last mail, knowing the passive interfaces can assist
the nodes or controller know the boundaries of the network.
Aijun Wang
China Telecom
> On Sep 30, 2020, at 19:47, Acee Lindem (acee) <[email protected]> wrote:
>
_______________________________________________
Lsr mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/lsr
_______________________________________________
Lsr mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/lsr
