2009/1/16 Jean-Michel Hautbois <jhautb...@gmail.com>: > 2009/1/16 Scott Wood <scottw...@freescale.com>: >> On Fri, Jan 16, 2009 at 01:06:06PM +0100, Jean-Michel Hautbois wrote: >>> Could it be a problem in my bootargs command line ? >>> I mean, maybe the console=ttyS0,11500 wrong ? >>> Because my "Run" LED is on... >>> >>> I tried ttyS0, ttyCPM0, tty0. >> >> It should be ttyCPM0, or just leave it out and make sure that >> /chosen/linux,stdout-path is set properly. >> >> Have you tried enabling early CPM debugging output? >> >> -Scott >> > > Well, I have to say, yes, I tried: > CONFIG_PPC_EARLY_DEBUG_CPM=y > CONFIG_PPC_EARLY_DEBUG_CPM_ADDR=0xf0001ff8 > > I have also tried without specifying the console outpût: > setenv bootargs root=/dev/ram rw > > Nothing more... > > JM >
OK, I just tried a make of my kernel (already compiled yesterday), and it generated a cuImage.mpc8272ads kernel image (which it didn't do yesterday). I don't know why this image was generated, but I tried to reboot using this one. And I am going further ! Hit any key to stop autoboot: 0 ## Booting kernel from Legacy Image at 01000000 ... Image Name: Linux-2.6.29-rc1-01197-g5a7b6e7- Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1529877 Bytes = 1.5 MB Load Address: 00400000 Entry Point: 00400b94 Verifying Checksum ... OK ## Loading init Ramdisk from Legacy Image at ff980000 ... Image Name: Simple Embedded Linux Framework Image Type: PowerPC Linux RAMDisk Image (gzip compressed) Data Size: 1730966 Bytes = 1.7 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 02000000 Booting using the fdt blob at 0x2000000 Uncompressing Kernel Image ... OK Loading Ramdisk to 039d7000, end 03b7d996 ... OK Loading Device Tree to 007fb000, end 007ff159 ... OK Memory <- <0xd00dfeed 0x2000> (0MB) ENET0: local-mac-address <- 00:00:00:00:00:7f ENET1: local-mac-address <- 00:00:00:00:00:00 CPU clock-frequency <- 0x0 (0MHz) CPU timebase-frequency <- 0x800 (0MHz) CPU bus-frequency <- 0x2000 (0MHz) zImage starting: loaded at 0x00400000 (sp: 0x03b7ebe0) Allocating 0x329908 bytes for kernel ... gunzipping (0x00000000 <- 0x0040d000:0x007591d8)...done 0x308b0c bytes Linux/PowerPC load: Finalizing device tree... flat tree at 0x767300 id mach(): done MMU:enter MMU:hw init MMU:mapin MMU:setio MMU:exit I am stuck there, with my eth LEDs blinking... JM _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
