The Freescale MPC8349e-MITX reference board has two TSECs, the second
of which (eth1) is attached to a Vitesse 7385 5-port switch.
Using the latest U-Boot, Kernel, and device tree, I cannot bring up
eth1. When I try, I get this message:
[EMAIL PROTECTED] root]# ifconfig eth1 up
0:01 not found
eth1: Could not attach to PHY
SIOCSIFFLAGS: No such device
Unfortunately, I don't even know what this means.
I believe my network configuration is correct. Here's what ifconfig
says about eth1:
eth1 Link encap:Ethernet HWaddr 00:E0:0C:00:8C:02
inet addr:192.168.2.141 Bcast:192.168.255.255 Mask:255.255.0.0
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Base address:0x4000
eth1 does work in U-boot, so I know it can be made to work (and I know
the 7385's firmware is uploaded), I just don't know what needs to be
done in Linux.
--
Timur Tabi
Linux kernel developer at Freescale
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
