On Fri, Aug 01, 2008 at 12:36:39PM -0500, Sparks, Sam wrote: > >From: Anton Vorontsov > >Sent: Friday, August 01, 2008 11:51 AM > > > >Works like a charm here. I use quite outdated u-boot though. Which one > >you use? I could try it (if it is community u-boot). > > I'm using the head, which I grabbed last week: U-Boot > 1.3.4-rc1-00012-g1953d12 > TIA for checking your itx with this version.
U-Boot 1.3.4-rc1-00012-g1953d12 (Aug 1 2008 - 21:45:42) MPC83XX The CF still works. > >As for the backtrace you posted recently, I remeber I've noticed the > >similar issue long ago on some mITX board. I believe the board had > >hw issues indeed (or CF card I tested with). The problem could be in > >the IRQ line itself (for some reason it always low), or it could be > >IDE cmd/data lines at fault, so that IDE can't receive status read > >command and does not deassert the interrupt line... quite hard to > >tell. > > Thanks for confirming.. I was losing my mind :-) > This looks like it is indeed a HW problem with the ITX. Are you aware of > any threads/documents describing the issue? We based our custom HW off > the ITX schematic with regards to the CF, and I hope we didn't copy over > _that_ problem :-/ I don't think it was a hw design problem, more likely somebody fried the CF slot on that board (either by hot-plugging the CF, or via inserting CF 5V only flash.. either of this is forbidden for the 8349mITX boards). -- Anton Vorontsov email: [EMAIL PROTECTED] irc://irc.freenode.net/bd2 _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
