Adding MIPS arch in the loop
On 09/20/2018 01:19 PM, Christophe LEROY wrote:
Le 20/09/2018 à 15:13, Michael Ellerman a écrit :
Joe Perches <j...@perches.com> writes:
On Tue, 2018-09-18 at 09:33 +0000, Christophe Leroy wrote:
On the below patch, checkpatch reports
WARNING: struct kgdb_arch should normally be const
#127: FILE: arch/powerpc/kernel/kgdb.c:480:
+struct kgdb_arch arch_kgdb_ops;
But when I add 'const', I get compilation failure
So don't add const.
checkpatch is stupid. You are not.
_Always_ take checkpatch bleats with very
large grains of salt.
Perhaps send a patch to remove kgbd_arch
from scripts/const_structs.checkpatch as
it seems not ever to be const.
I think it could/should be const though, it just requires updating all
arches.
Yes I was thinking about doing it, but first thing is to change the way
MIPS initialises it:
struct kgdb_arch arch_kgdb_ops;
int kgdb_arch_init(void)
{
union mips_instruction insn = {
.r_format = {
.opcode = spec_op,
.func = break_op,
}
};
memcpy(arch_kgdb_ops.gdb_bpt_instr, insn.byte, BREAK_INSTR_SIZE);
Can this be done staticaly ?
Christophe
