Hi,
On Mon, Jul 02, 2018 at 06:14:09PM +0530, Amit Kucheria wrote:
> SDM845 has two tsens blocks, one with 13 sensors and the other with 8
> sensors.
>
> Signed-off-by: Amit Kucheria <amit.kuche...@linaro.org>
> ---
> arch/arm64/boot/dts/qcom/sdm845.dtsi | 16 ++++++++++++++++
> 1 file changed, 16 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sdm845.dtsi
> b/arch/arm64/boot/dts/qcom/sdm845.dtsi
> index cdaabeb..edf8505 100644
> --- a/arch/arm64/boot/dts/qcom/sdm845.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sdm845.dtsi
> @@ -221,6 +221,22 @@
> #interrupt-cells = <2>;
> };
>
> + tsens0: tsens@c222000 {
> + compatible = "qcom,tsens-v2.4.0", "qcom,tsens-v2";
> + reg = <0xc263000 0x1ff>, /* TM */
> + <0xc222000 0x1ff>; /* SROT */
> + #qcom,sensors = <13>;
> + #thermal-sensor-cells = <1>;
> + };
> +
> + tsens1: tsens@c223000 {
> + compatible = "qcom,tsens-v2.4.0", "qcom,tsens-v2";
> + reg = <0xc265000 0x1ff>, /* TM */
> + <0xc223000 0x1ff>; /* SROT */
> + #qcom,sensors = <8>;
> + #thermal-sensor-cells = <1>;
> + };
> +
> spmi_bus: spmi@c440000 {
> compatible = "qcom,spmi-pmic-arb";
> reg = <0xc440000 0x1100>,
I tested this series on an SDM845 board. Temperatures can be read from
the tsens0 sensors, however for tsens1 sensors I get:
cat temp
cat: temp: No data available
TRDY_READY_BIT set when reading TRDY_OFFSET in get_temp_tsens_v2().
Unfortunately I currently have no documentation of the registers or the
thermal sensors in general and couldn't investigate further.
Any idea what could be the problem?
Thanks
Matthias
