On Mon, 29 Aug 2016 13:38:47 -0700
Brian Norris <computersforpe...@gmail.com> wrote:
> On Mon, Aug 29, 2016 at 11:59:30AM +0200, Boris Brezillon wrote:
> > On Mon, 29 Aug 2016 07:45:49 +0000
> > Karl Beldan <kbel...@baylibre.com> wrote:
> >
> > > This fixes subpage writes when using 4-bit HW ECC.
> > >
> > > There has been numerous reports about ECC errors with devices using this
> > > driver for a while. Also the 4-bit ECC has been reported as broken with
> > > subpages in [1] and with 16 bits NANDs in the driver and in mach* board
> > > files both in mainline and in the vendor BSPs.
> > >
> > > What I saw with 4-bit ECC on a 16bits NAND (on an LCDK) which got me to
> > > try reinitializing the ECC engine:
> > > - R/W on whole pages properly generates/checks RS code
> > > - try writing the 1st subpage only of a blank page, the subpage is well
> > > written and the RS code properly generated, re-reading the same page
> > > the HW detects some ECC error, reading the same page again no ECC
> > > error is detected
> > >
> > > Note that the ECC engine is already reinitialized in the 1-bit case.
> > >
> > > Tested on my LCDK with UBI+UBIFS using subpages.
> > > This could potentially get rid of the issue workarounded in [1].
> > >
> > > [1] 28c015a9daab ("mtd: davinci-nand: disable subpage write for
> > > keystone-nand")
> > >
> > > Signed-off-by: Karl Beldan <kbel...@baylibre.com>
> >
> > Acked-by: Boris Brezillon <boris.brezil...@free-electrons.com>
> >
> > Brian, can you take this patch directly in your tree. If that's not
> > possible, let me know, I'll add the Fixes and Cc:stable tags and take
> > it for 4.9.
>
> Would this be correct?
>
> Fixes: 6a4123e581b3 ("mtd: nand: davinci_nand, 4-bit ECC for smallpage")
I'd say so. At least this is where nand_davinci_hwctl_4bit() was
introduced, and it did not contain this 'reset' step.
>
> Brian
